Engineered Classics

Workshop & Fitting

Your swap, start to finish.

Until now, the biggest problem with a swap project wasn't finding the parts. It was knowing what to do with them once you had them, and finding a workshop that understood exactly what you wanted.

At VWheelswap we have built a complete process together with Bombita Motor Sport (BMS), the go-to workshop we work with to take your projects from paper to asphalt. Three phases, three people in charge, one result.

01

Planning

· VWheelswap

Before touching the car, you need to know exactly what's going to be done and in what order. This is the part that saves the most time and money on a project.

  • Reviewing the car and defining the right donor engine
  • Full parts list: mounts, driveshafts, gearbox, cooling, brakes, wiring
  • What can be reused from the donor and what needs to be bought new
  • A real project budget before you start
  • Supply of swap-specific parts from our shop
  • Coordination with BMS: workshop slot timing and work order

Without this phase, projects drag on, purchases get repeated and budgets spiral.

02

Execution

· Bombita Motor Sport (BMS)

Once the project is planned and the parts are ready, BMS takes over. They work with the projects we plan at VWheelswap because they know the process, they know the parts, and they know what it means to get it right the first time.

  • Removing the original engine and cleaning the engine bay
  • Preparing and fitting mounts and brackets
  • Fitting the donor engine with gearbox and driveshafts
  • Cooling system: radiator, intercooler and pipework
  • Wiring and ECU management
  • Exhaust system: manifold, downpipe and line
  • Brake system, if the project requires it
  • Tuning and first bench tests

The car doesn't leave the workshop until it's running right.

03

Finishing

· Homologation

A properly done swap needs to be properly signed off. In Spain, any engine modification requires a modification project signed by an engineer and approval at the ITV (Spain's roadworthiness test).

  • Drafting the technical modification project
  • Submission to the relevant authority
  • Support through the ITV inspection
  • Updating the vehicle's technical record

With this, the car is road-legal. Without it, the project isn't finished.

Compatibility

Which cars and which swaps?

Golf MK1 1974 – 1983
Golf MK2 1983 – 1992
Golf MK3 1992 – 1997
Caddy MK1 1979 – 1995
Scirocco MK1 and MK2
Corrado 1988 – 1995

Available swaps:  1.8T (AGU / AMK / BAM) ·  VR6 (AAA / ABV) ·  ABF 2.0 16v ·  Full builds and restorations

The first step

Have a project in mind?

Start with the consulting service. We review your car, your engine and your budget, and tell you exactly what you need and in what order. If you then book the full process with BMS, the cost of the consulting is deducted from the total.